ORDER OF THE MINISTER OF THE INDUSTRY AND INFRASTRUCTURE DEVELOPMENT OF THE REPUBLIC OF KAZAKHSTAN

of March 24, 2022 No. 151

About introduction of amendments to the order of the acting minister on investments and development of the Republic of Kazakhstan of March 26, 2015 No. 342 "About approval of admissible parameters of the vehicles intended for movement on highways of the Republic of Kazakhstan"

I ORDER:

1. Bring in the order of the acting minister on investments and development of the Republic of Kazakhstan of March 26, 2015 No. 342 "About approval of admissible parameters of the vehicles intended for movement on highways of the Republic of Kazakhstan" (it is registered in the Register of state registration of regulatory legal acts for No. 11009) the following changes:

in admissible parameters of the vehicles intended for movement on highways of the Republic of Kazakhstan, approved by the specified order:

state Item 1 in the following edition:

"1. Admissible dimensional parameters and other linear sizes of vehicles shall not exceed the stated below values (in meters):

1) admissible length:

single vehicles:

categories M1, N and O (trail car) 12,0;

categories Sq.m and M3 13,5;

categories Sq.m and M3 with more than two axes of 15,0;

categories Sq.m and M3 with 18,75 trail car;

the jointed buses of categories Sq.m and M3 18,75;

road trains as a part of the tractor and trail car (semitrailer truck) of 20,0;

2) admissible width:

all 2,55 vehicles;

isothermal bodies of 2,6 vehicles;

3) admissible height:

all 4,0 vehicles.";

exclude item 4;

state Item 13 in the following edition:

"13. The admissible mass of vehicles shall not exceed the stated below values (in tons):

1) single vehicles:

categories M, N and O (trail car):

two-axis 18,0;

three-axis (except for the jointed buses of category M3) 25,0;

for three-axis single vehicles exceeding of load of 1 ton is allowed in case the leading axes are equipped with duo-pitch wheels and load of each axis does not exceed 9,5 of tons;

the jointed buses of category M3 28,0;

eight-wheel, including with two managed 32,0 axes;

five-axis 38,0;

Disclaimer! This text was translated by AI translator and is not a valid juridical document. No warranty. No claim. More info